|  |  | | | | Modular Refrigeration Systems - Water Cooled Chiller Modules ( WCS ) |
| 
|
|
These water-cooled chiller modules are available in single or multiple compressor / refrigeration circuits, using single efficient semi-hermetic or scroll compressors as standard. With options to suit your needs, including open-drive or screw compressors, these modules are delivered pre-wired, pre-piped and factory tested. Sized from 10 to 300 tons or more and coupled with a BERG pump tank set and a cooling tower, this is a system created for years of economical and reliable service. | 
|
|
Because of the simple hookup required on BERG packaged chillers, customers usually have them running the same day as delivery. |

| Highlights - Compressor (HP) 20 - 120 or More!
- Cooling Capacity ( Refrigeration tons ) 15 to 300 or More!
( Multi-Cylinder, Semi Hermetic Compressor WS ) - Forced feed oil lubrication system Discharge and suction service valves
- Spring mounted to chiller main frame
- Suction, gas-cooled motor
( Multi-Cylinder, Direct Drive Compressor WO ) - Forced feed oil lubrication system
- Discharge service valve
- Solid mounted to chiller main frame
- NEMA approved open drip-proof motor
( Screw Compressor WZ ) - Discharge and suction service valves
- Solid mounted to chiller main frame
|
|
Chiller Vessel - High efficiency shell and tube construction
- Coded vessel Steel shell on water side
- Copper tube with inner fin on refrigerant side
Water-Cooled Condenser - Heavy construction while maintaining maximum heat transfer
- Steel shell on refrigerant side
- Copper tubing with outer fin on water side
- Removable heads for cleaning
| 
|
|

| Tested under load conditions prior to shipment All safety controls are factory set and checked Safety Controls - Freeze-up controls
- High and low refrigerant pressure controls
- Compressor motor overload protection
- Tank low-level cutout (glycol units)
- Oil pressure safety control
- Refrigerant pressure relief valve
|
|
Frame - Frame Manufactured from heavy gauge structured steel tube with welded construction.
Electrical- 460 / 575 / 230 / 380 Volts 60 / 50 Hz
- 120 Volt Single Phase Control Voltage
- Microprocessor Controller
- Operating and Fail Lights
- UL or CSA Approved Components
| 
|
|
Central Control Electrical Panel A custom electrical control panel allows one point hookup and may include; - HMI ( Human Interface Device ) touchscreens
- PLC ( Programable Logic Control )
- SCADA ( Supervisory Control And Data Acquisition ) Communication Systems
- 24/7 alarm reporting to beepers or cell phones
All pump starters, fuses, disconnect, control voltage transformer, run and fail lights, are housed in a common NEMA RATED panel. | 
|
|
Central Thermostat Control System This system is used to control chiller units in a multiple central chilling system. The temperature controller is located at the BERG tank and senses the process water temperature. The process water temperature is maintained by cycling the chiller units. |
|
|

|
|

|
|
| |
|
|
BERG Chilling Systems Inc. - Toronto Ontario Canada Industrial Refrigeration / Commercial Refrigeration / Process Pumps / Process Cooling Systems / HVAC Systems / Cooling Towers Tel: +01 (416) 755-2221 Fax: +01 (416) 755-3874 Email: bergsales@berg-group.com |
|