Indoor Refrigeration Units - Heat Recyclers Air Cooled Chiller Modules ( ACS )

BERG air-cooled modules are designed for applications where it is desirable to convert the heat from molds, rolls, etc. into hot air to heat the plant. These units, called "HEAT RECYCLERS", provide supplemental heating for the plant in the winter and ventilation during summer. This is achieved by changing the damper settings in the ductwork. (Sized from 20-70 tons.)

Highlights

• Compressor (HP) 20 - 120 or More!
• Cooling Capacity ( Refrigeration tons ) 15 to 300 or More!
• Heating (BTU/hr) 270k - 846k

( Multi-Cylinder, Semi Hermetic Compressor ACS )

• Forced feed oil lubrication system Discharge and suction service valves
• Spring mounted to chiller main frame
• Suction, gas-cooled motor

( Multi-Cylinder, Direct Drive Compressor ACO )

• Forced feed oil lubrication system
• Discharge service valve
• Solid mounted to chiller main frame
• NEMA approved open drip-proof motor

( Screw Compressor ACZ )

• Discharge and suction service valves
• Solid mounted to chiller main frame

Tested under load conditions prior to shipment
All safety controls are factory set and checked

Safety Controls

• Freeze-up controls
• High and low refrigerant pressure controls
• Compressor motor overload protection
• Oil pressure safety control
• Refrigerant pressure relief valve

     These air cooled chiller modules are recommended for applications with clean air and supplemental heat requirements.

     The ACS is part of BERG's complete line of heat reclaim chiller modules. These are used in conjunction with a BERG  Pump Tank Assembly to create a complete Central Chilled air cooled System.

     This system Reclaims waste energy to heat the plant during the winter months and superb ventilation during the summer months.

     BERG's  chillers incorporate high air flow to eliminate many of the problems associated with air stratification. All components are configured on the frame for easy maintenance and simple start-up.

Air Cooled Outdoor or Indoor Remote Condenser or Blower

• Heavy construction while maintaining maximum heat transfer
• Seamless copper tubing
• Aluminum fins
• Permanent metal-to-metal contact
• Dynamically balanced centrifugal blowers
• Blowers are belt-driven by an open, drip proof motor

Central Control Electrical Panel

     A custom electrical control panel allows one point hookup and may include;

• HMI ( Human Interface Device ) touchscreens
• PLC ( Programable Logic Control )
• SCADA ( Supervisory Control And Data Acquisition ) Communication Systems
• 24/7 alarm reporting to beepers or cell phones

     All pump starters, fuses, disconnect, control voltage transformer, run and fail lights, are housed in a common NEMA RATED panel.