Pumping Systems -  Single and Double ended Stainless Steel Tank  Process Pump Chiller Mixing

Multiple pumps configured on a double-ended
tank set or modular detachable pumping for shipping larger tanks

    A BERG Double Pump Tank System incorporates multiple pumps with a baffled holding tank.

    The chiller pump (usually the smaller one) circulates water / glycol from the hot side of the tank to the chiller module(s) and back to the cold side of the tank.

    This pump ensures constant flow and pressure required by the chiller(s) for maximum efficiency, as well as less chance of freeze-up due to the low flow condition.

    The process pump (usually the larger one) circulates the chilled water from the cold side of the tank to the process machines and other users.

    This pump is designed to match both flow and pressure required by the varying process load without affecting the chiller operation.

• 460 / 575 / 230 / 380 Volts 60 / 50 Hz
• 120 Volt Single Phase Control Voltage
• Microprocessor Controller
• Operating and Fail Light
• UL or CSA Approved Components

Chiller Pump / Recirculation Pump / Process Pump / Stand-by Pump

• Suction shut-off valve
• Discharge check valve
• Discharge flow control / shut-off valve
• Discharge pressure gauge.
• Fittings adequately sized for maximum flow

Standard Units 3/4 to 150 hp

Flow Rates from 50 to 8000 gpm or More!

      All pump starters are panel mounted on the side of tank or remote panel and are pre-wired to the pump motors. Starters can be controlled with manual Stop / Start switches and indicator lights or HMI ( Human Machine Interface ) type Logic Controller. Motor circuits are protected with premium quality overload protection.

Double Y-Strainer and Pressure Alarm

     BERG's unique system gives complete protection to water circulation equipment with absolutely no down-time. When water pressure across strainer drops to a selected critical level, the alarm and light are actuated. By manually switching to a secondary filter line, the original filter or strainer may be cleaned while maintaining circulation.

Central Control Electrical Panel

     A custom electrical control panel allows one point hookup and may include;

• HMI ( Human Interface Device ) touchscreens
• PLC ( Programable Logic Control )
• SCADA ( Supervisory Control And Data Acquisition ) Communication Systems
• 24/7 alarm reporting to beepers or cell phones

     All pump starters, fuses, disconnect, control voltage transformer, run and fail lights, are housed in a common NEMA RATED panel.